Panasonic DIGA DMR-EZ48V - Manual (Page 57)

57
RQT9056
, then
OK
11
Enter a 4-digit password with the
numbered buttons, then OK
– A screen appears confi rming that you have set a
password. Press [OK].
If you select “Off” for “Set”:
A screen appears confi rming that you haven’t set a
rating. Press [OK].
To change the password
Enter a 4-digit password with the
numbered buttons, then
OK
 ,  to select “Change
Password”, then
OK
Enter the new password with the
numbered buttons, then
OK
– A screen appears confirming that you have set a
password. Press [OK].
Tips
To clear the password
(
81, To reset the ratings level settings)
Notes
 Recording may fail when a wrong password was entered for
scheduled recording settings.
 “V-chip” technology enables restricted shows to be locked
according to TV ratings.
 The V-chip system that is used in this set is capable of blocking
“NR” programs (non rated, not applicable and none) as per
FCC Rules Section 15.120(e)(2). If the option of blocking “NR”
programs is chosen “unexpected and possibly confusing results
may occur, and you may not receive emergency bulletins or any of
the following types of programming:”
– Emergency Bulletins (Such as EAS messages, weather
warnings and others)
– Locally originated programming
 News  Political
– Public Service Announcements
 Religious  Sports  Weather
Off Timer
Select how long the unit remains on when it is not being used.
Perform steps 1−3 of “Accessing the Setup Menu” (
55).
,  to select “Setup”, then 
,  to select “Off Timer”, then
OK
,  to select “2 Hours”, “6
Hours” or “Off”, then OK
Remote Control
Perform steps 1−3 of “Accessing the Setup Menu” ( 55).
,  to select “Setup”, then 
,  to select “Remote Control”,
then
OK
,  to select “Set Code 1”, “Set
Code 2”, or “Set Code 3” then
OK
to set.
While pressing and holding OK ,
press and hold the numbered button
1 , 2 , or 3 corresponding to
the code set in step 6 for about
5 seconds to set.
OK
to complete.
After selecting “Parental Rating” ( 56, step 5).
Clock Settings
Perform steps 1−3 of “Accessing the Setup Menu” ( 55).
,  to select “Setup”, then 
,  to select “Clock
Settings”, then
OK
Use this function to synchronize the codes for the remote
control and the main unit.
Setting Men
us