Panasonic DIGA DMR-EZ48V - Manual (Page 83)

83
RQT9056
Cannot operate the TV or Set Top
Box with the unit’s remote control.  Change the manufacturer code on the remote control. 68
 Select TV or Set Top Box mode on the remote control. 68
Cannot operate the DVD.  Press [DRIVE SELECT] to select the DVD drive when operating DVDs or
CDs.
– Make sure the TV is on the correct channel or input mode.
17
Cannot operate the VHS.  Press [DRIVE SELECT] to select the VHS drive when operating VHS
cassettes.
– Make sure the TV is on the correct channel or input mode.
17
The remote control doesn’t work.  The remote control code is wrong. Change to the correct code. 57
 The batteries are depleted. Replace them with new ones. 5
 Point the remote control at the remote control sensor on the main unit. 5
 Remove obstacles between the remote control and main unit. −
 Remove dust from the transmission window and the unit’s sensor. −
 Colored glass may obstruct the signal reception/transmission. −
 Don’t place the signal sensor in direct sunlight or in areas that may be
subject to sun exposure.
−
 It may be necessary to set the code on the remote control again after
changing the batteries.
57
 It may be necessary to set the manufacturer code again after changing the
batteries.
68
The unit is on but cannot be
operated.  Some operations are prohibited by the disc. −
 The unit is warm (“U59” appears on the unit’s display). Wait until “U59”
disappears.
−
 One of the unit’s safety devices may have been activated.
Reset the unit as follows:
Press [
/I POWER] on the main unit to switch to off.
If the unit doesn’t switch to off, reset the unit ( 81, “To restore the unit if it
freezes”).
−
“U88” is displayed and the disc
cannot be ejected.  The unit is carrying out the recovery process. Do the following to eject the
disc:
(1) Press [
/I POWER] on the main unit to switch to off.
If the unit doesn’t switch to off, reset the unit ( 81, “To restore the unit if
it freezes”).
(2) While the unit is off, press and hold [ ] and [CH ] on the main unit
at the same time for about 5 seconds. (Ejection may take extra time
depending on discs.) The disc may be defective. Try another disc.
−
Cannot eject a disc.  The unit is recording. −
 The unit may have a problem. Eject the disc as in (2) above. −
Startup is slow.  Startup takes time in the following situations:
– A disc other than a DVD-RAM is inserted.
– The clock is not set.
– Immediately after a power failure or the AC power supply cord is
connected.
– When the unit is connected with an HDMI cable.
−
A password screen appears and
you are unable to view or record.  If the unit starts receiving a broadcast with the set rating information, a
password screen appears and you will be unable to view or record. Enter
your password to continue.
56
Time is incorrect after using Auto
Clock Setting.  Try again. If the time is still incorrect, set the clock manually. 58
General Issues Operation
Page
Ref
erence