Pioneer DEH-P9100R - Manual (Page 61)

Adjusting subwoofer settings
When the subwoofer output is on, you can
adjust the cut-off frequency and the output level
of the subwoofer.
1. Press AUDIO and NEXT and then press
SW2 to select the subwoofer setting
mode.
2. Press
2 2 or 3 3 to select the cut-off fre-
quency.
Each press of
2
or
3
selects cut-off fre-
quencies in the following order:
50
Ф
63
Ф
80
Ф
100
Ф
125 (Hz)
3. Press
5 5 or ∞ ∞ to adjust the output level of
the subwoofer.
Each press of
5
or
∞
increases or decreas-
es the level of the subwoofer.
• “+6” – “–24” is displayed as the level is
increased or decreased.
Note:
• “SW2” is not displayed when the subwoofer output
is off in the subwoofer output mode (SW1). In this
case, this mode is inactive.
U
sing the high pass filter
When the subwoofer is connected and you do
not want low sound to play from the front or rear
speakers, turn the high pass filter on. Only fre-
quencies higher than those in the selected
range will be output from the front or rear
speakers.
Setting the high pass filter for front
speakers
1. Press AUDIO and NEXT and then press
HPF F to select the high pass filter mode.
2. Press HPF F to turn the high pass filter
on.
“HPF ON” appears in the display.
• Press HPF F again to turn the high pass fil-
ter off.
3. Press
2 2 or 3 3 to select a high pass filter
range.
Each press of
2
or
3
selects frequencies in
the following order:
50
Ф
63
Ф
80
Ф
100
Ф
125 (Hz)
Setting the high pass filter for rear
speakers
1. Press AUDIO and then press NEXT twice.
2. Press HPF R to select the high pass filter
mode.
3. Press HPF R to turn the high pass filter
on.
“HPF ON” appears in the display.
• Press HPF R again to turn the high pass
filter off.
4. Press
2 2 or 3 3 to select a high pass filter
range.
Each press of
2
or
3
selects frequencies in
the following order:
50
Ф
63
Ф
80
Ф
100
Ф
125 (Hz)
60
ENGLISH
ESPAÑOL
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS