Panasonic CF-50 - Manual (Page 17)

17
Operation
3
Log on to Windows
Windows 2000
Wait for 10 seconds after confirming that the hard disk drive access has been completed,
input the user name and password, then select [OK]. Until the correct user name and
password are entered, the computer will not operate.
Windows XP
Wait for 10 seconds after confirming that the hard disk access has been completed, select
the user and input the password, then select . Until the correct password is entered, the
computer will not operate.
4
Select your application
You are able to start working on your computer.
The power saving function is factory set, so if there is no input from a key, the touch pad
or an external mouse (when one is connected) for a certain interval of time, the power to
the LCD and hard disk may be turned off. The LCD will resume operation when the
touch pad or an external mouse (when one is connected) is used or a key is pressed.
The power to the LCD may be turned off even when an application software is being
installed. In this case, because it is conceivable that a selection dialog box will be
shown, do not press Space or Enter to attempt to resume from this condition as
doing so may trigger a selection, but instead, press a key unrelated to the direct trigger-
ing of a selection, like Ctrl .
In addition, when the computer is left alone, it automatically enters the standby or hiber-
nation mode (
“Standby/Hibernation Functions”). The computer will resume
by pressing the power switch.
Windows XP
When switching to a different user with the Fast User Switching function, it may not be
possible to set the settings of the display. In this case, log on with the administrator authority
again, not using the Fast User Switching function, and try the operation once more.
NOTE
When an application or file that was previously displayed ap-
pears on your screen
The standby or hibernation mode has been set ( “Standby/Hibernation Func-
tions”).
Enter your password* and press Enter .( “Security Measures”)
Will Start
Will Not Start
(Power off)
If [Enter Password] is displayed
* Supervisor Password or User Password set in the Setup Utility (not
the Windows password).
Three incorrect attempts
or
No password for about a minute
The correct password
Enter Password [ ]