PhatNoise KDC-W6531 - Manual (Page 10)

10 | English
General features
Attenuator
Turning the volume down quickly.
Press the [ATT] button.
Each time the button is pressed, the Attenuator
turns ON and OFF.
When it’s ON, the "ATT" indicator blinks.
System Q
You can recall the best sound setting preset for
different types of music.
1 Select the source to set
Press the [SRC] button.
2 Select the Sound type
Press the [Q] button.
Each time the button is pressed, the sound
setting switches.
Sound setting Display
User memory "USER"
Rock "ROCK"
Pops "POPS"
Easy "EASY"
Top 40 "TOP40"
Jazz "JAZZ"
Natural "NATURAL"
• User memory: The values set on the <Audio Control>
(page 10).
• Each setting value is changed with the <Speaker
Setting> (page 11).
First, select the speaker type with the Speaker setting.
Audio Control
1 Select the source for adjustment
Press the [SRC] button.
2 Enter Audio Control mode
Press the [VOL] knob.
3 Select the Audio item for adjustment
Press the [VOL] knob.
Each time the knob is pressed, the items that can
be adjusted switch as shown below.
4 Adjust the Audio item
Turn the [VOL] knob.
Adjustment Item Display Range
Subwoofer level *¹ "SW L" –15 — +15
Bass level*² "BAS L" –8 — +8
Middle level*² "MID L" –8 — +8
Treble level*² "TRE L" –8 — +8
Balance "BAL" Left 15 — Right 15
Fader "FAD" Rear 15 — Front 15
Exit Audio Control mode
• * 1 You can control this item when <Switching preout>
(page 26) is set to "SWPRE SW".
• * 1 You can control this item when <Subwoofer
Output> (page 11) is set to "SW ON".
• * 2 Source tone memory: The set up value is put in the
memory per source.
5 Exit Audio Control mode
Press any button.
Press the button which is not [VOL] knob and
[ATT]/ [ANG] button.