PhatNoise KDC-W6531 - Manual (Page 11)

English | 11
Audio Setup
Setting the Sound system, such as Cross over
Network.
1 Select the source for adjustment
Press the [SRC] button.
2 Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
3 Select the Audio Setup item for adjustment
Press the [VOL] knob.
Each time the knob is pressed, the items that can
be adjusted switch as shown below.
4 Setup the Audio item
Turn the [VOL] knob.
Adjustment Item Display Range
Front High Pass Filter "HPF" Through/40/60/80/100/120/
150/180/220 Hz
Rear High Pass Filter "HPR" Through/40/60/80/100/120/
150/180/220 Hz
Low Pass Filter* 1 "LPF" 50/60/80/100/120/Through
Hz
Subwoofer Phase* 1 "PHAS" Normal (0°)/ Reverse (180°)
Volume offset "V-OFF" –8 — ±0
Loudness "LOUD" OFF/ON
• Volume offset: Each source’s volume can be set as a
difference from the basic volume.
• Loudness: Compensating for low and high tones
during low volume.
When it's ON, "LOUD" indicator is ON.
• * 1 You can control this item when <Switching preout>
(page 26) is set to "SWPRE SW".
• * 1 You can control this item when <Subwoofer
Output> (page 11) is set to "SW ON".
5 Exit Audio Setup mode
Press [VOL] knob for at least 1 second.
Speaker Setting
Fine-tuning so that the System Q value is optimal
when setting the speaker type.
1 Enter Standby
Press the [SRC] button.
Select the "STANDBY" display.
2 Enter Speaker Setting mode
Press the [VOL] knob.
3 Select the Speaker type
Turn the [VOL] knob.
Each time the knob is turned, the setting
switches as shown below.
Speaker type Display
OFF "SP OFF"
For 5 & 4 in. speaker "SP 5/4"
For 6 & 6x9 in. speaker "SP 6x9/6"
For the OEM speaker "SP OEM"
4 Exit Speaker Setting mode
Press the [VOL] knob.
Subwoofer Output
Turning the Subwoofer output ON or OFF.
Hold down on [AM] of the Control knob for at
least 1 second.
Each time the button is pressed, Subwoofer
output switches ON and OFF.
When it’s ON, "SW ON" is displayed.
• You can control this function when <Switching
preout> (page 26) is set to "SWPRE SW".