Paradyne COMSPHERE 3615 - Manual (Page 80)

Unit Configuration
5-15 3615-A2-GB20-20 December 1996
Table 5-4
(3 of 3)
DBM Port Configuration Options
CCN by EL: Disab
Next Enab Disab Prev
Configuration Change Notification by External Leads. Controls using the general-purpose output leads to set a CCN
event. This configuration option only has an effect if
Ext Leads is set to ExtLd.
Enab — Change in state of a general-purpose lead signals CCN to the NMS.
Disab — General-purpose lead changes do not set a CCN event.
DTR Alarm: Disab
Next Enab Disab Prev
Data Terminal Ready Alarm. Causes the DSU to generate an alarm if DTR is Off for more than 30 seconds. The DCP
displays
DTR Alarm and reports the alarm to the NMS.
Enab — If DTR lead turns Off for 30 seconds, the DSU generates an alarm.
Disab — Regardless how long the DTR lead is Off, no alarm is generated.
Async
→
Sync: Enab for DiDg, Disab for SyBC and SyBT configurations
Next Enab Disab Prev
Asynchronous-to-Synchronous Conversion. Sets the DBM port for asynchronous or synchronous operation.
Enab — Configures the DBM as asynchronous (asynchronous-to-synchronous conversion takes place).
Disab — Configures the DBM as synchronous.
AsyncBit/Char: 8 for DiDg configuration
Next 6 7 8 9 10 Prev
Asynchronous Bits per Character. Specifies the length of a character, including the parity bit but excluding the start and
stop bits. This configuration option only applies to the Dial Diagnostic (DiDg) configuration.
6 to 10 — Selects the asynchronous bits per character. When Stop Bits is set to 2, 10 will not be displayed.
Stop Bits: 1 for DiDg configuration
Next 1 2 Prev
Stop Bits. Specifies the number of stop bits in an asynchronous character. This configuration option only applies to the
Dial Diagnostic (DiDg) configuration.
1 to 2 — Selects the number of stop bits to be used. When the AsyncBit/Char configuration option is set to 10, 2
will not be displayed.
Overspeed: 2.3 for DiDg, not applicable for other configurations
Next 1.0 2.3 Prev
Overspeed. Selects the overspeed range of the asynchronous-to-synchronous converter. This configuration option is
only displayed when the Async
→
Sync configuration option is enabled.
1.0 — Selects the basic overspeed range. Basic range provides 1.0 % overspeed in the DTE or router
asynchronous data rate.
2.3 — Selects the overspeed percentage for extended range. Extended range provides 2.3% overspeed in the
DTE or router asynchronous data rate.