Polaris Indy 340 Touring - Manual (Page 47)

44
THE PERFECT FIT
EDGE Touring Suspension (ETS) Adjustments
The following information has been compiled to assist you in tuning
your ETS to its maximum potential.
The Ride Control Adjuster (RCA)
1. Refer to the initial setup reference chart (located under the hood of
your snowmobile and on page 43) to determine the desired RCA
position.
2. To adjust, loosen the hex bolts attaching the rear lower shock cross
shaft to the rail beam. See illustration.
3. Using a 9/16" wrench, loosen the jam nuts on the preload bolts.
4. Adjust the preload bolts to the desired RCA position.
5. Tighten the jam nuts.
NOTE: Make sure the preload bolt contacts the slide block before tight-
ening the jam nut.
6. Tighten the hex bolts and torque to 35 ft. lbs. (47 Nm).
NOTE: The RCA setting is the primary rear suspension adjustment. It
will have the MOST effect on rear suspension performance.
Preload Bolt
Jam Nut
Hex Bolt