Polaris Indy 340 Touring - Manual (Page 90)

87
MAINTENANCE
Lubrication
Jackshaft Bearing
Loosen the driven clutch retaining
bolt and pull the clutch outward to
expose the bearing and grease fit-
ting. Inject grease into the grease
fitting in the flangette until grease
purges from inside or outside the
bearing seal (may take only two
pumps). Push the clutch back onto
the shaft and replace the clutch
retaining bolt. Torque to 18 ft. lbs.
(24.4 Nm).
Driveshaft Bearing
Inject grease into the fitting on the
speedometer sensor housing until
grease purges from the seal on the
inside of the tunnel. This should
take approximately two pumps.
Do not use more than four pumps.
Coupler Greasing
(WideTrak)
Grease the couplers on
the driveshaft and jack-
shaft.
✪
✪
✪
✪
✪
Jackshaft
Driveshaft
Tr
an
smi
ssion