Piega SUB 1 MKII - Manual (Page 9)

Connecting the System
PIEGA P SUB 1 MKII
Configuration example for stereo and surround mode
Dolby Digital System - Surround System with NF Out
The 5.1 receivers and power amplifiers of some manufacturers have a separate NF Out terminal. The terminal allows the signal
to reach the subwoofer without any amplification. Refer to the appropriate manual for information about operation and connection
options for your AV receiver/power amplifier.
Note:
Frequently used configuration
>Ideal configuration for stereo mode...!
CROSSOVER
FREQUENCY
40Hz 140Hz
LFE / IN
INPUT
OUTPUT
L R
60Hz
PRE OUT
L
R
Right Left
230V T3. 15AL250V FOR 230V INPUT T5AL250V FOR 115V INPUT 115/230V - 50/60HZ 500W
Front
Speaker R
Front
Speaker L
Center
Speaker
Rear
Speaker R
Rear
Speaker L
Amplifier
L+
L-
R+
R-
SPEAKER LEVEL INPUTS
Connection:
>Connect the P SUB 1 MKII cable to the AV receiver terminal
marked PRE OUT (or similar)
>Connect the P SUB 1 MKII cable to the subwoofer terminal
marked INPUT
>For this use connection cables with cinch plugs (not supplied)
>Connect the loudspeakers using the loudspeaker terminals provided
on your AV receiver/power amplifier
9