Planet Technology WAP-1966 - Manual (Page 18)

- 13 -
devices on a network. It is commonly used for network administrators to communicate with multiple
devices (hub, switch, router
……) for configuring and monitoring while convenient for
troubleshooting but no miscellaneous platform consideration. The built-in SNMP is an agent, which
watches the status of it self. The Network Management Station (A computer attached to network with
SNMP management program well installed) can be used to access it.
System Location: Input the system location for NMS to identify this AP.
System Contact: Input the system contact for NMS to identify this AP.
Community: A valid entry of Community String is for authentication to login to the SNMP agent for
reading information.
Trap Receiver: Trap receiver specifies the Network Management Stations (NMS) that will receive
trap messages from the SNMP agent of WAP-1966.
3.2 Configure through 22M AP Utility
The 22M AP Utility is provided to configure the WAP-1966. It can be used to configure multiple
WAP-1966s at the same time in an easiest way.
3.2.1 Install 22M AP Utility
1. Insert the User ’s Manual and Utility CD into the CD-ROM drive.
2. Run “setup.exe” under “E:\Utility\WAP-1966\” directory, or click the “Start” button and choose
“Run”. When the dialog box appears, enter “E:\Utility\WAP-1966\setup.exe” (Assume “E” is your
CD-ROM drive). You will see the dialog box as below. Please click
“Next” to continue.
3. You can click “Browse” to specify the Destination Folder that you want to install the utility. Or you
can keep the default setting and click ”Next” to continue.