Pride Mobility Dynamic DX - Manual (Page 6)

6 Basic Operation Manual SCR
SCR CONTROLS
The SCR has only two built-in controls: the On/Off Switch and the Mode
Switch (see figure 1). The On/Off Switch simply controls power to the SCR.
The Mode Switch cycles the SCR through eight possible program modes.
Only five of the eight possible program modes are used in the Standard Mode
Configuration. All five program modes are Drive Modes (see Standard Mode
Configuration).
STANDARD MODE CONFIGURATION
Quantum Rehab’s Standard Mode Configuration for the SCR encompasses
five drive programs, all of which control driving speed as a percentage of
maximum speed. The slowest is Drive Mode 1; the fastest is Drive Mode 5.
Actual maximum speed varies according to the power chair model.
Driving in Standard Mode Configuration
Driving in Standard Mode Configuration is simple. Power up the SCR using
the On/Off Switch (either onboard or plugged into the external On/Off Switch
jack). The LCD Display will show Drive Mode 1 and prompt the user to
select one of three options (see figure 2):
DRIVE MODE 1
PREVIOUS
YES
NEXT
Figure 2. Drive Program Selection
1. Previous (down arrow)
-Returns the SCR to the previous
state (in this case, powered
down)
2. Yes (right arrow)
-Selects Drive Program 1
3. Next (up arrow)
-Selects the next option (in this
case, Drive Program 2)
Using the input device, select the drive program most appropriate to the
current environment, e.g., indoor setting versus outdoor setting. Choosing
the “Next” command will cycle the SCR through the drive programs. The
LCD display will change with each option selection.