Powermatic 60HH - Manual (Page 8)

8
Unpacking
Open shipping cartons and check for shipping
damage. Report any damage immediately to
your distributor and shipping agent. Do not
discard any shipping material until the Jointer is
assembled and running properly.
Compare the contents of your cartons with the
following parts list to make sure all parts are
intact. Missing parts, if any, should be reported
to your distributor. Read the instruction manual
thoroughly for assembly, maintenance and
safety instructions.
Contents of the Shipping Container
The following are included with both straight and
helical cutterhead models
(see Figures 2, 3, 4):
1 Jointer
Assembly (A)
1 Stand Assembly (B)
1 Switch Arm (C)
1 Dust Chute (D)
1 Drive Belt (E)
1 Door
(F)
2 Push Blocks (G)
1 Handwheel
(H)
1 Cutterhead Guard (J)
2 Open End Wrenches, 12/14, 8/10mm (K)
1 Hex (Allen) Wrenches, 3mm, 6mm (L)
1 Screwdriver
(M)
1 Hardware Bag containing:
3 Carriage Bolts, 3/8”-16 x 2-3/8” (AA)
6 Flat Washers, 3/8” (BB)
3 Lock Washers, 3/8” (CC)
3 Hex Nuts, 3/8” (DD)
4 Socket Head Cap Screws, 5/16”-18x3/4”
(EE)
4 Flat Washers, 5/16” (FF)
4 Lock Washers, 5/16” (GG)
4 Pan Head Screws, 1/4”-20 x 1/2” (HH)
4 Flat Washers, 1/4” (JJ)
2 Pan Head Screws, M6 x 12 (KK)
2 Flat Washers, M6 (LL)
1 Owner's Manual (not shown)
1 Warranty Card (not shown)
Included with straight cutterhead models (60C)
only:
1 Knife Setting Gauge Assembly (N)
Included with helical cutterhead models (60HH)
only (see Figure 5):
2 Star Point Screwdrivers (O)
5 Knife
Inserts (P)
10 Knife Insert Screws (R)
Figure 2
Figure 3
Figure 4
Figure 5 (helical cutterhead only)