Panasonic CF-T5 Series User Manual
Page 13
13
G
ett
in
g S
ta
rte
d
U
se
ful
In
formati
on
Trouble
s
hooting
Appendi
x
The battery charging starts automatically.
CAUTION
z
Do not disconnect the AC adaptor and do not switch the wireless switch to on
until the first-time operation procedure is completed.
z
When using the computer for the first time, do not connect any peripheral device
except the battery pack and AC adaptor.
z
Handling the AC adaptor
• Problems such as sudden voltage drops may arise during periods of thunder
and lightning. Since this could adversely affect your computer, an uninterrupt-
ible power source (UPS) is highly recommended unless running from the bat-
tery pack alone.
Slide and hold the power switch
for approximately one second until the
power indicator
lights.
CAUTION
z
Do not slide the power switch repeatedly.
z
The computer will forcibly be turned off if you slide and hold the power switch for
four seconds or longer.
z
Once you turn off the computer, wait for ten seconds or more before you turn on
the computer again.
z
Do not perform the following operation until the hard disk drive indicator
turns off.
• Connecting or disconnecting the AC adaptor
• Sliding the power switch
• Touching the keyboard, touch pad or touchscreen
• Closing the display
z
Do not change the Setup Utility until completing step 5. If you do so, Windows
setup may not operate properly.
Follow the on-screen instructions.
z
The computer will restart after the setup is complete.
To go to the next step, wait until the hard disk drive indicator
has turned
off.
CAUTION
z
When you set date/time/time zone and click [Next], the screen may not go to the
next step for a few minutes. Do not touch the keyboard or touch pad, and wait
until the screen changes.
Click [start] - [Control Panel] - [User Accounts] - [Create a new account].
CAUTION
z
Remember your password. If you forget the password, you cannot use the Windows
operation system. Creating a password reset disk beforehand is recommended.
A
Click [start] - [All Programs] - [Fujitsu Touch Panel (USB)] - [Touch Screen
Calibration Utility].
B
Using the stylus, touch each of the 12 “+” target marks one by one until it
blinks, and then click [Calibration].
C
Click [Save & Exit].
NOTE
z
Regarding Windows XP
You can select the Classic view of Control Panel or the Classic Start menu. You can also change the way a user logs
on or off. This manual explains using the Windows XP default setting (not Classic view or Classic Start menu etc.).
z
Windows Update
You can update to the latest patches and service packs for Windows with the following menus.
3
Connect your computer to a power outlet.
3
4
Turn on the computer.
5
Setup Windows.
6
Create a new account.
7
Perform the touchscreen calibration.
4
CF-T5mk2.book 13 ページ ２００６年９月２９日 金曜日 午前８時３４分