Panasonic CF-T5 Series User Manual
Page 19
19
G
ett
in
g S
ta
rte
d
U
se
ful
In
formati
on
Trouble
s
hooting
Appendi
x
NOTE
z
Consult Absolute Software Corp. before disposal.
z
Refer to the following URL for Computrace
®
software for installation and available service regions. Note that this
service is only available in certain regions.
http://www.absolute.com
1
Turn on or restart the computer, and press
F2
while [Panasonic] boot screen is dis-
played.
The Setup Utility starts up.
z
If the password is requested, enter the Supervisor Password.
2
Select the [Security] menu, then select [Computrace (R) Sub-Menu] and press
Enter
.
3
Select [Computrace (R) BIOS Module], and set to [Enable].
4
At the confirmation message, select [Execute] and press
Enter
.
5
At the reconfirmation message, select [Execute] and press
Enter
.
6
Press
F10
.
At the confirmation message, select [Yes] and press Enter.
The computer restarts.
To clean display (LCD)
Use the soft cloth included with the computer. (For more information, refer to “Suggestions About Cleaning the LCD
Surface” that comes with the soft cloth.)
To clean areas other than the LCD panel and touch pad
Wet a soft cloth with water or a diluted kitchen cleanser (neutral), wring the cloth out thoroughly, and wipe the dirty area
gently. Using a detergent other than a neutral kitchen cleanser (e.g., a weak alkali cleanser) may adversely affect
painted surfaces
CAUTION
z
Do not use benzene, thinner, or rubbing alcohol since it may adversely affect the surface causing discoloration, etc.
Do not use commercially-available household cleaners and cosmetics, as they may contain components harmful to
the surface.
z
Do not apply water or detergent directly to the computer, since liquid may enter inside of the computer and cause
malfunction or damage.
Maintenance
CF-T5mk2.book 19 ページ ２００６年９月２９日 金曜日 午前８時３４分