Pioneer 2010 NAVIGATION UPGRADE SD-CARD CNSD-130FM - Manual (Page 122)

Correcting the current location
Touch the screen to adjust the current position
and direction of the vehicle displayed on the
map.
1 Display the
“Settings Menu” screen.
= For details of the operations, refer to Dis-
playing the
“Settings Menu” screen on
page 115.
2 Touch [Location].
3 Scroll to the position where you want
to set, then touch [OK].
Checking the connections
of leads
Check that leads are properly connected be-
tween the navigation system and the vehicle.
Please also check whether they are connected
in the correct positions.
1 Display the
“Settings Menu” screen.
= For details of the operations, refer to Dis-
playing the
“Settings Menu” screen on
page 115.
2 Touch [Connection].
The
“Connection” screen appears.
2
3
1
1 GPS Status
Indicates the connection status of the GPS
antenna, the reception sensitivity and from
how many satellites the signal is received.
Color
Signal com-
munication Used in posi-
tioning
Orange Yes Yes
Yellow Yes No
2 Hand Brake
When the parking brake is applied,
“On” is
displayed. When the parking brake is re-
leased,
“Off” is displayed.
3 Illumination
When the headlights or small lamps of a ve-
hicle are on,
“On” is displayed. When the
small lamps of a vehicle are off,
“Off” is dis-
played. (If the orange/white lead is not con-
nected,
“Off” appears.)
Adjusting the response
positions of the touch panel
(touch panel calibration)
If you feel that the touch panel keys on the
screen deviate from the actual positions that
respond to your touch, adjust the response po-
sitions of the touch panel screen.
p Make sure to use the supplied stylus for ad-
justment and gently touch the screen. If
you press the touch panel forcefully, the
touch panel may be damaged. Do not use
a sharp pointed tool such as a ballpoint
pen or a mechanical pen, which could da-
mage the screen.
Stylus (supplied with the navigation
system)
1 Display the
“Settings Menu” screen.
= For details of the operations, refer to Dis-
playing the
“Settings Menu” screen on
page 115.
2 Touch [Calibrate].
A message confirming whether to start the ca-
libration appears.
3 Touch and hold the target that point to
the center and corners of the LCD screen.
The target indicates the order.
4 Touch anywhere on the screen.
The adjusted position data will be saved.
p Do not turn off the engine while saving the
adjusted position data.
En
122
Chapter
26 Customizing preferences