Peerless Industries Peerless-Av Dukane Projector Short Throw Wall Arm UST-WallArm3 - Manual (Page 10)

10 of 14
ISSUED:07-25-11 SHEET #: 125-9225-1
FRONT OF PROJECTOR
FRONT OF PROJECTOR
Installation using Wall Arm Bracket and Extension Bracket
FRONT OF PROJECTOR
9
10
DETAIL 2
B
C
Snap extension cap ( U) into extension bracket (B) in orientation as shown in figure 9.1.
Slide wall plate cover ( E) onto wall arm bracket (C).
Slide extension bracket ( B) into wall arm bracket (C) in desired position.
TIGHTEN
SCREWS H
I
SECOND HOLE
MAY ALSO BE
USED IF DESIRED
I
KEYHOLE
NOTE: Verify that all screws
are in the center of the slot.
T
FIGURE 9.2 FIGURE 9.1
B
U
PROJECTOR POSITION FOR 70" - 100" SCREEN SIZE
E
DETAIL 3 DETAIL 4
R
Requirements for Shim Spacer
1. When the front pre-fastened M5 x 20 mm socket pin serrated washer head screw (R) of the adapter plate
assembly ( A) goes through the extension bracket (B) and wall arm bracket (C).
2. When there is a gap between the bottom of the projector attachment bracket ( H) and the extension bracket (B).
NOTE: If Shim spacer plate (I) is not required skip to step 11
Position exposed M5 x 20 mm socket pin serrated washer head screws ( R) through slot in extension bracket (B) and
wall arm bracket ( C).Position screws in keyholes in projector attachment bracket (H), and hole in shim spacer plate
( I) as shown in detail 3. Slide projector attachment bracket (H) toward wall. Once in locked position tighten all three
M5 x 20 mm socket pin serrated washer head screws ( R) using security wrench (Q) as shown in detail 4.
Secure extension bracket ( B) into wall arm bracket (C) and secure using four M5 x 10 mm socket pin screws (T) in
desired position. NOTE: Make sure that four M5 x 10 mm socket pin screws (T) are used.
SKIP TO STEP 12.
A
R
R