Warning, Po d d j – Peerless Industries Peerless-Av Dukane Projector Short Throw Wall Arm UST-WallArm3 User Manual
Page 5
5 of 14
ISSUED:07-25-11 SHEET #: 125-9225-1
Using wall plate (
D) as a template, drill four 5/32" (4 mm) dia. holes to a minimum depth of 2.5" (64 mm). Attach
wall plate (
D) to centers of wood studs using four #14 x 2.5" wood screws (J) shown in figure 1.1.
Fasten wall arm bracket (
C) loosely to wall plate (D) using four M5 x 8 mm pan head black screws (P), and
four #10 black washers (
O).
Installation to Single Wood Stud Wall
1
P
O
D
D
J
DIAMOND INDICATES
TOP OF WALL PLATE
C
fig 1.1
fig 1.2
• Installer must verify that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
• Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder
is highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Install-
ers are responsible to provide hardware for other types of mounting situations.
WARNING