Pioneer XV-DV9 - Manual (Page 17)

Connecting up 02
17
En
Connecting using the component
video output
If your TV has component video inputs, you can
use these instead of the standard video output
to connect this system to your TV. This should
give you the best quality picture from the three
types of video output available.
• Use a component video cable (not
supplied) to connect the COMPONENT
VIDEO OUT to a set of component inputs
on your TV.
• The component video output is switchable
between interlaced and progressive
formats. See
Video Output settings on
page 70 and Watching progressive scan
video from the component video outputs
below for more on this.
Watching progressive scan video from
the component video outputs
Compared to interlace video, progressive scan
video effectively doubles the scanning rate of
the picture, resulting in a very stable, flicker-
free image. Progressive scan video is available
only from the component video output. There
are a few things to keep in mind when
switching the
Component Out (page 70)
setting to Progressive :
• When set to Progressive , there is no video
output from the VIDEO OUT (composite)
and S (S-video) jacks.
• If you want to display video on more than
one monitor simultaneously, make sure
the player is set to
Interlace .
Important
• If you connect a TV that is not compatible
with a progressive scan signal and switch
the setting to
Progressive , you will not be
able to see any picture at all. In this case,
press
STANDBY/ON to put the system
in standby, then press and hold the front
panel
(stop) button for about 8 seconds
until the display shows Mem.Clr.? . Press
the front panel or button
so that the display shows Interlace? . Press
the front panel button to set to
interlace and switch the system back on.
When TV format is set to AUTO or NTSC :
• When set to Progressive , PAL and NTSC
discs are both output as progressive NTSC
video. See also
TV format setting on
page 75.
• When set to Progressive , there is no video
output from the VIDEO and S-VIDEO
jacks. If you want to display video on more
than one monitor simultaneously, make
sure that it is set to
Interlace . See also TV
format setting on page 75.
VIDEO
CONTROL
P R
P B Y
COMPONENT
VIDEO OUT
SUB
WOOFER L R
FRONT
S-VIDEO
OUT
VIDEO
OUT
SPEAKERS
IN
TV
COMPONENT
INPUT
XV-DV9.book 17 ページ ２００４年２月２０日 金曜日 午前１１時４２分