Pioneer XV-DV9 - Manual (Page 78)

Additional information 12
78
En
Place on an unstable surface, or one that is
not large enough to support all four of the
system unit’s feet.
Cleaning the pickup lens
The DVD player’s lens should not become dirty
in normal use, but if for some reason it should
malfunction due to dust or dirt, consult your
nearest Pioneer authorized service center.
Although lens cleaners are commercially
available, we do not recommend using them
since some may damage the lens.
Problems with condensation
Condensation may form inside the system unit
if it is brought into a warm room from outside,
or if the temperature of the room rises quickly.
Although the condensation won’t damage the
system, it may temporarily impair its
performance. For this reason you should leave
it to adjust to the warmer temperature for
about an hour before switching on and using.
Moving the system unit
If you need to move the main unit, first remove
all discs, then press
STANDBY/ON on the
front panel to turn the system off. Wait for
Good Bye to disappear from the display, then
unplug the power cord. Never lift or move the
system during playback—discs rotate at a high
speed and may be damaged.
• Unplugging the system before Good Bye
disappears from the display may cause the
system to return to the factory settings.
Power cord caution
Handle the power cord by the plug part. Do not
pull out the plug by tugging the cord, and never
touch the power cord when your hands are
wet, as this could cause a short circuit or
electric shock. Do not place the system unit, a
piece of furniture, or other object on the power
cord or pinch the cord in any other way. Never
make a knot in the cord or tie it with other
cords. The power cord should be routed so that
they are not likely to be stepped on. A damaged
power cord can cause a fire or give you an
electric shock. Check the power cord once in a
while. If you find it damaged, ask your nearest
Pioneer authorized service center or your
dealer for a replacement.
Wireless speaker system
maintenance and precautions
• Even when not in use, the fan in the
wireless speaker will continue to operate.
Switching off the wireless speaker when
not in use will increase product life.
Cleaning the exterior
Use a polishing cloth or dry cloth to wipe off
dust and dirt. If the surfaces are very dirty, wipe
with a soft cloth dipped in some neutral
cleanser diluted five or six times with water and
wrung out well, then wipe again with a dry
cloth.
Do not use furniture wax or cleaners. Never
use thinners, benzine or insecticide sprays or
other chemicals on or near this unit since they
will corrode the surface.
If you use a chemical-impregnated cleaning
cloth, read the instructions carefully before
use. These cloths may leave smear marks on
half-mirror finish surfaces; if this happens,
finish with a dry cloth.
Make sure to unplug the unit when cleaning.
XV-DV9.book 78 ページ ２００４年２月２０日 金曜日 午前１１時４２分