Panasonic KX-MC6040 - Manual (Page 61)

9. Programmable Features
61
Setting the Error Correction
Mode (ECM)
{#}{
4}{1}{3}
This feature is available when the sending / receiving fax machines are ECM
compatible.
{
0} “ Off”: Deactivates this feature.
{ 1} “ On” (default): Fax transmission / reception will be carried out so that the
errors do not occur.
Setting the connecting tone
{#}{
4}{1}{6}
If you often have trouble when sending faxes, this feature allows you to hear
connecting tones: fax tone, ring back tone and busy tone. You can use these
tones to confirm the status of the other party’s machine.
{
0} “ Off”: Deactivates this feature.
{ 1} “ On” (default): You will hear connecting tones.
Note:
L If the ring back tone continues, the other party’s machine may not be a fax
machine or may have run out of paper. Check with the other party.
L The connecting tone volume cannot be adjusted.
Setting the maximum fax
speed
{#}{
4}{1}{8}
{ 1} “ 14.4Kbps”
{ 2} “ 33.6Kbps” (default)
Note:
L The fax speed maybe lower than the selected speed depending on your
line.
Activating the Distinctive
Ring feature
{#}{
4}{3}{0}
{ 0} “ Off” (default)
{ 1} “ On”
See page 55 for details.
Setting the ring pattern for fax
(Distinctive Ring feature)
{#}{
4}{3}{1}
{ 1} “ A”
{ 2} “ B”
{ 3} “ C”
{ 4} “ D”
{ 5} “ B-D” (default)
See page 55 for details.
Setting auto reduction
feature
{#}{
4}{3}{2}
To receive a fax document that is longer than your recording paper.
{
0} “ Off”: The unit will print received documents at their original size.
{ 1} “ On” (default): The unit will scale received documents to fit your recording
paper.
Changing the fax activation
code
{#}{
4}{3}{4}
If you wish to use an extension telephone to receive faxes, activate this feature
and program the activation code.
Important:
L The fax activation code must be different from the code that you
programmed on the answering machine.
{ 0} “ Off”
{ 1} “ On” (default)
1. {Menu} i {#}{4}{3}{4}
2. Press {1} to select “ On”. i {Set}
3. Enter your code from 2 to 4 digits, using 0–9, {*} and {#}.
L The default code is “; #9”.
L Do not enter “0000”.
4. {Set} i {Menu}
Feature/Code Selection