Panasonic VL-GM001 - Manual (Page 13)

13
• Check that there are no scraps from
the board or other debris in the
connector before installing it.
■ Remove the front case from the bottom case
Bottom case
Front case
While pushing the tabs at the top of the front case, pull the top of the front case
forward to disengage the front tabs one by one, and then pull the top of front
case forward to remove it.
Remove the connector screw, and then remove the connector.
Do not pull the wire
when removing the
connector.
Introduction and Installation
6
Remove the sheet covering the connector. Next, after
installing the terminal cover in the bottom case, attach
the connector by tightening the connector screw.
Next, align the lower portion of the bottom case with
the lower portion of the front case and press on the
panel area just above the screen until the tabs lock in
place.
Connector screw
Screwdriver +