Panasonic VL-GM001 - Manual (Page 16)

16
To attach the wires
• Strip off of the wire cover so that about 9 mm ( 3 /
8
″) of the wire is exposed.
• While pressing on the button with a pointed object such as a screwdriver, insert
the wire into the terminal connector.
• To disconnect a wire, press on the button while pulling out.
Introduction and Installation
Note:
• To open the case again, push the bottom of the front case, then release from the
rear case.
To attach the power cable
• While pressing on the button hard with a pointed object such as a screwdriver,
insert the power cable into the terminal connector.
• To disconnect the power cable, press on the button hard while pulling out.
• To attach an optional power cable, cut off about 12 mm (
1 /
2
″) of the cable cover
( ), then push in firmly until the end of the cable is securely inserted into the
power connection terminal ( ).
Sub Monitor station
Button
Terminal
connector
Button
Terminal
connector
Power cable cross section
Correct Incorrect
DC terminal