Panasonic TH-37PH10UK - Manual (Page 37)

37
1/2
PC
OFF
STANDBY SAVE OFF
POWER MANAGEMENT OFF
AUTO POWER OFF OFF
OSD LANGUAGE ENGLISH (US)
COMPONENT/RGB-IN SELECT
RGB
INPUT LABEL
SIGNAL
POWER SAVE
SET UP
1/2
PC
OFF
STANDBY SAVE OFF
POWER MANAGEMENT OFF
AUTO POWER OFF OFF
OSD LANGUAGE ENGLISH (US)
COMPONENT/RGB-IN SELECT
RGB
INPUT LABEL
SIGNAL
POWER SAVE
SET UP
3D Y/C FILTER (NTSC)
COLOR SYSTEM
SIGNAL
ON
AUTO
3 : 2 PULLDOWN
Panasonic AUTO (4 : 3) OFF
NORMAL
[ VIDEO ]
VIDEO NR OFF
SYNC
VIDEO NR
SIGNAL
AUTO
H-FREQ.
V-FREQ.
kHz
Hz
33.8
60.0
[ RGB ]
3 : 2 PULLDOWN OFF
OFF
3 : 2 PULLDOWN
VIDEO NR
SIGNAL
OFF
OFF
[ COMPONENT ]
3 : 2 PULLDOWN
VIDEO NR
SIGNAL
OFF
OFF
H-FREQ.
V-FREQ.
kHz
Hz
33.8
60.0
[ Digital ]
3:2 PULLDOWN / VIDEO NR
COLOR SYSTEM / Panasonic AUTO
Select SIGNAL from the “SET UP” menu during VIDEO (S VIDEO) input
signal mode.(“SIGNAL [VIDEO]” menu is displayed.)
SET UP for Input Signals
Press to select the “COLOR SYSTEM” or “Panasonic
AUTO”.
Press to select each function.
If the image becomes unstable:
With the system set on Auto, under conditions of low
level or noisy input signals the image may in rare
cases become unstable. Should this occur, set the
system to match the format of the input signal.
Press to select 3:2
PULLDOWN or VIDEO NR.
Press to set ON/OFF.
Press to exit from adjust mode.
3:2 PULLDOWN: When ON, the display attempts to reproduce a more natural interpretation of sources such as movie
pictures, which are recorded at 24 frames per second.
If the picture is not stable, turn the setting to OFF.
Notes:
When ON, this setting only affects the following signal input:
• NTSC / PAL signal input during “VIDEO (S VIDEO)” input signal.
• 525i(480i), 625i(575i), 1125(1080)/60i signal input during “COMPONENT” input signal.
VIDEO NR: Automatically reduces unwanted picture noise.
Note:
VIDEO NR cannot be adjusted while a PC signal is being applied.
1
2
Press ACTION ( ) button
Mode Function
COLOR SYSTEM Set the color system to match the input signal. When selecting “AUTO”, the color system is automatically
selected from NTSC/PAL/SECAM, however, M.NTSC signal is not displayed properly depending on
the attached terminal board. To display M.NTSC signal, select “M.NTSC” in COLOR SYSTEM.
AUTO SECAM M.NTSC NTSC PAL
Panasonic AUTO
(4 : 3 ) Set to “NORMAL” to view 4:3 images in an unchanged format when Panasonic AUTO is
selected. If you would like to view 4:3 images in Just format, set to “JUST”.
3D Y/C FILTER (NTSC)
COLOR SYSTEM
SIGNAL
ON
AUTO
3 : 2 PULLDOWN
Panasonic AUTO (4 : 3) OFF
NORMAL
[ VIDEO ]
VIDEO NR OFF
Press ACTION ( ) button
Note:
Panasonic AUTO does not function when BNC Dual Video Terminal Board (TY-FB9BD) is used.