Panasonic TH-37PH10UK - Manual (Page 9)

9
1 2
SERIAL PC IN
AUDIO
SLOT1 SLOT2 SLOT3
VIDEO P R /C R /R P B /C B /B Y/G AUDIO R L
COMPONENT/RGB IN
AUDIO R L AUDIO R L
AV IN B A
S VIDEO
1
2
1
2
SPEAKERS
Terminals (R)
SPEAKERS
Terminals (L)
– Cable fi xing bands
Secure any excess cables with bands as required.
When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker’s Installation Manual for details on speaker installation.
(Example: TH-42PH10UK)
Speakers (Optional accessories)
Pass the attached cable
fi xing band through the clip
as shown in the fi gure. To secure cables connected to Terminals, wrap the cable fi xing band around them then
pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band.
From SERIAL
Terminal on
Computer
(see page 11)
From EXTERNAL
monitor terminal
on Computer
(see page 10)
AC cord connection (see page 13)
Dual Video Terminals
(equivalent of BNC
Dual Video Terminal
Board (TY-FB9BD))
(see page 12)
To tighten:
To loosen:
Pull
Pull
Push the catch
Notes:
• At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.
• TH-37PH10UK has two slots only.
– AC cord fi xing
Optional Terminal
Board Insert Slot
(covered)
COMPONENT/RGB IN and
Audio IN Terminals (equivalent
of BNC Component Video
Terminal Board (TY-42TM6A))
(see page 12)
Connections
Note:
Make sure that the AC cord is locked on both the left and right sides.
Plug the AC cord into the display unit.
Plug the AC cord until it clicks.
Unplug the AC cord
Unplug the AC cord
pressing the two
knobs.
Note:
When disconnecting the AC cord, be
absolutely sure to disconnect the AC
cord plug at the socket outlet fi rst.