Panasonic AJ-P2C016RG - Manual (Page 171)

171 Menu: Menu Description Tables
Me
nu
Items/
Data Saved
Adjustable
Range
Remarks
USR SW F.RATE (1080-59.94i,
1080-23.98PsF,
1080-24PsF)
1FRAME
:
24FRAME
:
30FRAME
(1080-50i)
1FRAME
:
25FRAME
When the FRATE function has been
assigned to a user button, the starting
frame rate under VFR operation is set.
When the mode has been changed
using other settings and the frame rate
value set here exceeds the maximum
frame rate allowed by the set mode, the
maximum frame rate is changed to the
maximum frame rate of the set mode.
S C U F R
SCAN REVERSE ON
OFF
This setting is for correcting an image
which has been inverted by a film-use
lens or anamorphic lens attached to the
unit.
S C U F R
PC MODE SEL USB HOST
USB DEV. This is for setting the operations mode of
this unit when PC MODE is set to “ON”
and an external device is connected to
the USB connector.
USB HOST:
Allows data transfer from the unit
to the USB-connected device.
USB DEV.:
Allows data transfer from the
USB-connected device to the
unit.
Note
When the PC MODE menu option is set
to “ON”, no change can be made to this
option.
– – – F –
PC MODE ON
OFF Used to enable or disable the mode that
allows the unit to be connected to a PC
or an external hard disk drive via
USB 2.0.
ON:
Sets the unit to the mode
selected through the PC MODE
SELECT menu option.
OFF: Disables the PC MODE for
normal operation.
Note
Once the power is turned off, the option
is always set to “OFF” when the power is
turned on next time.
– – – F –
OPTION MODE
Items/
Data Saved
Adjustable
Range
Remarks
ACCESS LED OFF
SLOT SIDE
LCD SIDE
BOTH Specify whether or not to enable the P2
card access LEDs.
OFF:
Disables both LEDs above the
slots and on the side panel.
SLOT SIDE:
Enables the LED above the slots
and disables the LED on the side
panel.
LCD SIDE:
Enables the LED on the side
panel and disables the LED
above the slots.
BOTH: Enables both LEDs above the
slots and on the side panel.
– C U F –
P.OFF GPS
DATA HOLD
CLEAR Select whether or not to hold the UMID
GPS position information while the
power is turned off, thereby keeping this
information as status data holding the
previous value until the power is turned
on again, which enables a new
measurement to start.
HOLD: Hold and save the data.
CLEAR: Clear the data when the power is
turned off, and save zero (No-
Info) from the next power-on
until a new measurement is
completed.
– C U F –
SDI METADATA ON
OFF
Used to specify whether or not to output
metadata (UMID) to HD SDI.
– C U F –
SAVE SW (AUD
OUT) ON
OFF Select whether or not to forcibly disable
the audio output when the SAVE ON/
OFF switch is set to [ON].
ON:
Disable audio output.
OFF: Enable audio output.
– C U F –
SAVE SW (LCD) ON
OFF
Select whether or not to automatically
turn off the LCD monitor when the SAVE
ON/OFF switch is set to [ON].
ON:
Turn off LCD monitor.
OFF: Do not turn off LCD monitor.
– C U F –
AJ-HPX3700G-VQT1V68_eng.book 171 ページ ２００８年１０月１５日 水曜日 午後６時３８分