Panasonic AJ-P2C016RG - Manual (Page 21)

21 Parts and their Functions: Shooting and Recording/Playback Functions Section
P
ar
ts
and
thei
r F
unc
tions
13. TEXT MEMO button
Records a text memo if pressed during recording or
playback or when playback is paused.
Also, with appropriate menu settings, the TEXT MEMO
button can be used as a USER 4 button. For more
information on user buttons, refer to [Assigning
Functions to User Buttons] (page 59)
14. SAVE ON/OFF switch
Used to select the power supply method for each output
section.
ON: The output selected through the menu option
SAVE SW is power-saved. This option can be
found on the <OPTION MODE> screen on the
SYSTEM SETTING page.
OFF: Power saving is canceled.
Note
The ON/OFF switch does not function during recording.
The ON/OFF status changes after recording is
completed.
15. HD SDI A · B (output signal selector) switch
Changes the mode of the signals output through the HD
SDI A · B connector.
MEM:
Video from the camera is output during
recording and when recording is paused.
Playback signals are output from the P2 card
during playback.
CAM: Video from the camera is output constantly.
OFF: Video is not output, and the unit operates in
power-saving mode.
Note that the audio output is synchronized with the
video.
For types of video outputs, refer to [Settings of signals
output from HD SDI A · B connector] (page 89) and
[Settings of signals output from MON OUT connector]
(page 90).
16. MON OUT CHARACTER switch
This switch controls the superimposition of characters
onto the video output from the MON OUT connector.
ON: Characters are superimposed.
OFF: Characters are not superimposed.
For types of characters, see [Settings of signals output
from MON OUT connector] (page 90).
17. HD SDI A connector
This connector is for outputting video. A video signal
based on the setting of the 15. HD SDI A · B switch is
output. LinK A signal is output while in Dual Link output.
Note
Camera image is output from the HD SDI A connector
even during playback while in Dual Link (RGB 4:4:4)
output.
18. MON OUT (monitor output) connector
The MON OUT connector is used for outputting video
for the monitor. The output signal can be switched
between a down-converted (analog composite) signal
and an HD SDI signal. This connector outputs video
based on the setting of the 19. MON OUT SEL (output
signal selection) switch. Through an internal menu
option, the characters can be superimposed
independently of the HD SDI A · B connector. For more
information, refer to [Settings of signals output from
MON OUT connector] (page 90).
31
32
33
15
19
21 20
17
30
24
27
25
28 18 29
26
22 23
14 16
1
2
3
11
10 9 8
12
13 4
5
6
7
AJ-HPX3700G-VQT1V68_eng.book 21 ページ ２００８年１０月１５日 水曜日 午後６時３８分