Precision Power PC6800 - Manual (Page 9)

7
POWER / GROUND and REMOTE
Once you have run both the power and ground wires, it's time
to connect the cables to the amplifier. Cut off excess wire and,
using wire strippers, strip the ends of the power and ground
cables approximately 1/4 inch. Locate the
PowerLock power
and ground connector (supplied). With a small flat bladed screw
driver, loosen the screws before attempting to insert the cables.
Insert the wires into the appropriate hole, and tighten the
screws. Once the wires are secure, the
PowerLock may be
plugged into the amplifier. The Power/Ground PowerLock will
accommodate 4 gauge wire for the Pro6800 .
Power/Ground PowerLock
Fastening screws
Connect to Amplifier
Power wires
BACK TO CONTENTS