Caution for ac mains lead – Panasonic D-Snap SV-AS10 User Manual

Page 7

Advertising
background image

7

(For UK only)

Caution for AC mains lead

For your safety, please read the following
text carefully.

This appliance is supplied with a
moulded three-pin mains plug for your
safety and convenience. A 5-ampere
fuse is fitted in this plug.
Should the fuse need to be replaced,
please ensure that the replacement fuse
has a rating of 5-amperes and it is
approved by ASTA or BSI to BS1362.
Check for the ASTA mark

Ï or the BSI

mark

Ì on the body of the fuse.

If the plug contains a removable fuse cover
you must ensure that it is refitted when the
fuse is replaced. If you lose the fuse cover,
the plug must not be used until a
replacement cover is obtained. A
replacement fuse cover can be purchased
from your local Panasonic Dealer.

IF THE FITTED MOULDED PLUG IS
UNSUITABLE FOR THE SOCKET
OUTLET IN YOUR HOME THEN THE
FUSE SHOULD BE REMOVED AND
THE PLUG CUT OFF AND DISPOSED
OF SAFELY.
THERE IS A DANGER OF SEVERE
ELECTRICAL SHOCK IF THE CUT OFF
PLUG IS INSERTED INTO ANY
13-AMPERE SOCKET.

If a new plug is to be fitted, please
observe the wiring code as shown below.
If in any doubt, please consult a qualified
electrician.

_ IMPORTANT

The wires in this mains lead are coloured
in accordance with the following code:
Blue:

Neutral

Brown:

Live

As the colours of the wires in the mains
lead of this appliance may not correspond
with the coloured markings identifying the
terminals in your plug, proceed as follows:

The wire which is coloured BLUE must be
connected to the terminal in the plug
which is marked with the letter N or
coloured BLACK.

The wire which is coloured BROWN must
be connected to the terminal in the plug
which is marked with the letter L or
coloured RED.

Under no circumstances should either of
these wires be connected to the earth
terminal of the three-pin plug, marked
with the letter E or the Earth Symbol

Ó.

Before Use
Remove the Connector Cover as follows.

_ How to replace the Fuse

1

Remove the Fuse Cover with a
screwdriver.

2

Replace the fuse and attach the Fuse
Cover.

Connector
Cover

Fuse
Cover

Fuse

SV-AS10_EB.book 7 ページ 2003年9月4日 木曜日 午後4時3分

Advertising