Pride Mobility SC3450 - Manual (Page 36)

36 Revo
AXLE BEARINGS AND THE MOTOR/TRANSAXLE ASSEMBLY
n These items are all prelubricated, sealed, and require no subsequent lubrication.
CONSOLE, CHARGER, AND ELECTRONICS
n Keep these areas free of moisture.
n If any of these items do become exposed to moisture, let them dry thoroughly before operating your scooter
again.
STORAGE
If you plan on not using your scooter for an extended period of time, it is best to:
n Fully charge its batteries prior to storage.
n Disconnect the wiring harness from the back of the battery/charger pack.
n Store your scooter in a warm, dry environment.
n Avoid storing your scooter where it will be exposed to temperature extremes.
For prolonged storage, you may wish to place several boards under the frame of your scooter to raise the scooter off
of the ground. This takes the weight off the tires and reduces the possibility of flat spots developing on the areas of the
tires contacting the ground.
REAR LIGHTS
The light bulbs for the rear running lights are easily replaceable.
To replace a bulb:
n Remove the light cover which is held in place with Phillips head screws.
n Gently remove the bulb by pulling it straight up.
n Insert a new 24V, 5-watt bulb.
n Replace the light cover.
NOTE: Replacement light bulbs can be purchased from your authorized Pride provider.
X I I . C A R E A N D M A I N T E N A N C E
CAUTION! Do not use regular automotive-type 12-volt light bulbs; your scooter is equipped
with a 24-volt electrical system.