Promise Technology FastTrak TX4000 User Manual
Page 61
Chapter 6: Troubleshooting & Tips
57
To remove the Reserve Sector, follow these steps:
1.
During boot up, press Ctrl-F to enter the FastBuild BIOS utility.
2.
Choose option 2, View Drive Assignments.
3.
Press arrow keys to highlight the drive where you wish to remove the
reserve sector.
4.
Press Alt-F1. The highlighted drive will start blinking on the screen.
5.
Press Ctrl-Tab. A message will appear that says the reserved sector (which
is where array information is kept) on the disk will be wiped.
6.
Press Y to confirm.
7.
Take the appropriate action:
•
For striped arrays, repeat this process for each member of the
particular array that is having a problem. When you are finished, press
the Esc key twice to reboot.
•
For mirrored arrays, hit the Esc key twice to reboot.
8.
After rebooting, use FastBuild to re-create the array.
•
For striped arrays, use FDISK and FORMAT after setting up the array.
•
For mirrored arrays, rebuild the mirrored array.
Array Constantly Goes Into Critical or Offline Mode During Reboot
(see Unable to Partition or Format array above)
Cannot Rebuild Mirrored (RAID 1) Array
(see Unable to Partition or Format array above)
Fatal Errors or Data Corruption Are Constantly Reported When Reading or
Writing to Drive Array
(see Unable to Partition or Format array above)