Operations, Selecting an input source, Before you begin, make sure you have – Pioneer PRO-1000HDI User Manual
Page 26
22
PRO-1000HD
I
/ PRO-800HD
I
Selecting an Input Source
This section explains the basic operation of this unit.
Outlined on the following pages is how to turn the main
power on and off, put this unit in the operation or standby
mode and how to select connected components.
Before you begin, make sure you have:
• Made connections between this unit and AV components
or personal computer as described in the section
“Installation and Connections” starting on page 8.
• Set up the on-screen menu to input signals from
components connected to INPUT1 and INPUT2 as
described in the section “Setting Up the System” on
page 18.
If no connections are made to these terminals,
on-screen setup is not necessary.
2,5
3
1
Switch the main power switch on the main unit to
the on position to turn the main power on.
The STANDBY/ON indicator lights red.
2
Press STANDBY/ON to put this unit in the
operation mode.
The STANDBY/ON indicator turns green.
Operations
3
Press INPUT on the remote control unit or the
main unit to select the input.
Input changes each time the main unit’s INPUT is
pressed as follows.
• When the menu screen is displayed, changing the
signal input will cause the menu screen to turn off.
• If the input computer signal is not supported by the
display, the following message will be displayed:
:
0
8 5
5
1
2
6
8
4
k
H z
f V
.
:
1
7
1
7
H z
f H
.
P O
U S UP
N
S
R E D
T
I
N AL
G
CA U
I O N
T
F U L L
I N P U T 1
X
:
0
2 0
– – – –
k
H z
f V
.
:
7
7
1
5
H z
f H
.
T
OU
N
O
A
R
F
G E
CA U
I O N
T
F U L L
I N P U T 1
4
Use VOLUME +/– on the remote control unit to
adjust the volume.
If no audio connections are made to this unit, this step
is not necessary.
5
When viewing is finished, press STANDBY/ON to
put the unit in standby mode.
The STANDBY/ON indicator will blink and then remain
lit (red) indicating that the standby mode is engaged.
Operation is not possible while the STANDBY/ON
indicator is blinking (red).
6
Switch MAIN POWER on the main unit to the off
position to turn the main power off.
The STANDBY/ON indicator may continue to light for a
short while even after the main power is turned off.
This is a result of residual electric load impressed on
the circuitry, and the light will turn off presently.
CAUTION
Please do not leave the same picture displayed on the screen for
a long time. Doing so may cause a phenomenon known as
“screen burn” which leaves a ghost, or residual, image of the
picture on the screen.
Remote Control Unit
Main Unit Operating
Panel
2,5
3
4
3 INPUT1
INPUT5
2
3 INPUT3
INPUT4
2
3 INPUT2