Perle Systems 5500161-40 - Manual (Page 251)

251
Settings
I/O UDP Settings
Configure the following parameters:
UDP Entry
Start IP Address
End IP Address
Port
When enabled, broadcasts I/O status (data) to the specified range of IP
addresses.
Default: Disabled
The first host IP address in the range of IP addresses (for IPV4 or IPV6) that
the IOLAN will listen for messages from and/or send messages to.
Field Format: IPv4 or IPv6 address
The last host IP address in the range of IP addresses (for IPV4, not required for
IPV6) that the IOLAN will listen for messages from and/or send messages to.
Field Format: IPv4 address
The UDP port that the IOLAN will use to relay messages to servers/hosts.
Default: 0 (zero)