Planar PX23MW - Manual (Page 12)

u
Connecting the Display (Figure 10.1)
To setup this display, please refer to the following figure and procedures.
1. Be sure all equipment is turned off.
2. Connect the DC power cord to the power connector; plug one end of the
AC power cord into the power adapter, and the other end into an
electrical outlet(Œ).
3. For the PC with Analog output: Connect the VGA signal cable from
display VGA input connector to the 15-pin connector of your host
computer and tighten the screws().
4. For the PC with DVI digital output: Connect the DVI signal cable to the
connector of the display card in your computer; connect the other side to
the DVI-D input port of your display. Tighten the screws(Ž).
5. If your video source uses a round, four-prong S-Video connector,
please use the S-Video cable().
6. If your video source uses a round, one-prong composite video connector,
please use the video cable().
7. If your audio source uses a round, one-prong composite audio connector,
please use the audio cable(‘).
8. Turn on your computer, display and video source.
Start Your Installation
Notice:To ensure the LCD Display will work well with your computer,please
configure the display mode of your graphics card to make it less than or
mode is compatible with the LCD screen. We have listed the “Compatibility
Modes” of this LCD screen in appendices for your reference.
8
equal to 1920 x 1200 resolution and make sure the timing of the display