Panasonic AJ- HD3700B - Manual (Page 17)

– 17 –
Controls and their functions
Connector section
Remote control section
(26) REMOTE IN RS-422A serial mode input connector.
connector
(RS-422A) (9P)
(27) REMOTE OUT RS-422A serial mode output connector.
connector
(RS-422A) (9P)
(28) REMOTE IN/OUT RS-422A serial mode I/O connector.
connector (9P)
(29) V/A CONTROL Encoder remote (AJ-ER50) connector. (see Note)
terminal (15P)
(30) RS-232C Data communication is possible by connection to a personal computer or a
connector (25P) modem.
(31) CONTROL PANEL For connection of the cable of a control panel.
connector (20P) The control panel connector enables the connectors on the front panel and
connectors on the rear panel to be connected, and when these connectors are
simultaneously connected, it is possible to switch between them using the menu.
(32) PARALLEL 50-pin parallel remote connector.
(IN/OUT) terminal (Mainly for connection of equipment produced by the user.)
(50P)
O Note N
The AJ-ER50 “Video input” and “VIDEO-PHASE” functions are not operational, as there is no correspondence with this
recorder. Also, SYS-PHASE should be set at this recorder and not at the AJ-ER50.
~ AC IN
SIGNAL GND
OUTPUT CH CH CH CH
INPUT CH CH CH CH
HD
HD
REMOTE IN
ON
OFF
1 2 3
(SUPER)
(SUPER)
IN IN OUT
HD SDI SD SDI WFM VIDEO OUT REF IN
REF OUT DIGITAL AUDIO
1 OUT1
OUT2 OUT 2
OUT 3
MONITOR
MONITOR (SUPER) SPARE
ACTIVE THROUGH
REMOTE OUT REMOTE IN/OUT
CONTROL PANEL
V/A CONTROL RS-232C
PARALLEL IN/OUT
(50P)
SD
SD
SD
ON
OFF
FUSE
125V 5A
ACTIVE THROUGH
(26) (27) (28) (29) (30)
CH 1 CH 2 CH 3 CH 4
CH 1 CH 2 CH 3 CH 4
CUE
CUE
L R
OUT IN
AUDIO OUT
AUDIO IN
MONITOR
TIME CODE
PUSH PUSH PUSH PUSH PUSH PUSH
(31) (32)
75 Ω 75 Ω
3
4 π 1
2 π 7
8 π 5
6 π
7
8 π 5
6 π 3
4 π 1
2 π