Pioneer DVR-440H-S - Manual (Page 19)

Connecting up 02
19
En
1 Connect RF antenna cables as shown.
This enables you to watch and record TV
channels.
2 Use a SCART cable (not supplied) to
connect the AV1(RGB)-TV AV connector
to a SCART AV connector on your TV.
This enables you to watch discs.
3 Use another SCART cable to connect
the AV2(INPUT 1/DECODER) AV
connector to a SCART AV connector on
your cable box/satellite/digital terrestrial
receiver.
This enables you to record scrambled TV
channels.
4 Plug the supplied G-LINK™ cable to
the G-LINK™ jack.
This enables you to control the tuner in the
external receiver using the GUIDE Plus+®
system.
Position the IR transmitter end of the G-
LINK™ cable so that the IR receiver on your
cable/satellite/digital terrestrial receiver will
pick up the control signals (see diagram).
See the manual that came with your cable/
satellite/digital terrestrial receiver if you’re
not sure where the IR receiver is on the front
panel. Alternatively, experiment with the
remote control, operating it from very close
range until you find the place where the
receiver responds.
Tip
• This recorder has a ‘through’ function
which allows you to record a TV program
from the built-in TV tuner in this recorder
while watching a video playing on your
VCR. (To use this feature when the
recorder is in standby,
Power Save
must be set to Off —see Power Save on
page 116).
TV
Satellite dish/
antenna/cable TV
wall outlet
Cable/Satellite/
Digital Terrestrial
receiver
AC IN DIGITAL OUT CONTROL
G-LINK COAXIAL IN S-VIDEO VIDEO AUDIO
L R
COMPONENT VIDEO OUT
Y
P B
P R
ANTENNA
IN
OUT
OUTPUT
AV 1 (RGB) – TV AV 2 (INPUT 1/DECODER)
SCART AV
CONNECTOR
SCART AV
CONNECTOR
ANTENNA
IN
ANTENNA
IN (RF IN)
ANTENNA
OUT
ANTENNA
OUT
ANTENNA
IN
1
1
2
3
1
4
DIGITAL OUT CONTROL
G-LINK COAXIAL IN AUDIO
L R
COMPONENT VIDEO OUT
Y
P B
P R
OUTPUT
AV 1 (RGB) – TV
G-LINK cable
DVR540H_WV_EN.book 19 ページ ２００６年２月１６日 木曜日 午後４時３４分