Procom PRO-COM SFE33RE-O - Manual (Page 7)

7
(Adaptor NOT permitted in Canada)
Under CZ22.2 NO. 0 standard
6
6. Flame Effect setting:
(1) Flame speed
After selecting MANUAL mode or AUTO mode, the
flame symbol will flash, for slow flame effect, press
button, for faster flame effect, press button.
(2) Flame brightness
Press “SET” button, when the lamp symbol flashes,
press
button to decrease the flame brightness
and button to increase the flame brightness.
7. For Flame Effect only:
Select MANUAL mode, then set the Heating level to
no heating level or select AUTO mode and then set
temperature to lowest setting.
8. Manual ON/OFF button
If you can’t find your Remote Control or the Remote
Control is damaged, you can use manual ON/OFF
button to manual turn on/turn off your heater.
2. The Clock setting :
Press the “CLOCK” button, the figure shown on clock will
flash. Press
or to set the hour. After the hour has
been set, press the “CLOCK” button again to set the
minutes. After the minutes has been set, press the “CLOCK”
button, the clock will indicate the set time.
3. The Timer setting :
Press the “TIMER” button, the word “TIMER” will appear on
the transmitter, next press
or to adjust the time, to
add 30 minutes increments press the button again. After
the timer has been set, press “TIMER” button again, the
word “TIMER” will flash and the timer will return to time.
4. Key-Press Lock setting (child proof):
To lock, press the “LOCK” button, there will be a symbol,
which means that the transmitter is in a lock position. To
unlock, press
once immediately followed by pressing
the “LOCK” button .
5. Heating Level setting
Select the MANUAL model and press SET to chosse the
heating level setting, the “
“ symbol will flash. Then
press or to select full, half or no heating.