Pioneer S-DV555T - Manual (Page 42)

Additional information 10
42
En
Tuner
USB connection
Error Messages
Files don’t show up in
the Disc Navigator/
Photo Browser. • The files on the disc must be named with the correct file extension: .mp3 for MP3
files; .wma for WMA files; .m4a for MPEG-4 AAC files; .jpg for JPEG files (upper or
lower-case is OK). See
Disc compatibility table on page 36.
Can’t play WMA or
MPEG-4 AAC files. • The files were recorded using DRM (digital rights management). This is not a
malfunction.
Problem Remedy
Problem Remedy
Considerable noise in
radio broadcasts. • Connect the AM antenna (refer to the Setup Guide ) and adjust the direction and
position for best reception. You may also connect an additional internal or external
AM antenna (refer to
Connecting external antennas on page 31).
• Fully extend the FM wire antenna, position for best reception, and secure to a
wall. You may also connect an outdoor FM antenna (see
Connecting external
antennas on page 31).
• Turn off other equipment that may be causing the noise or move it further away.
• The tuning interval is incorrect for your country or region. See
Frequency step
setting on page 34 to switch the tuning interval.
Auto tuning does not
pick up some stations. • The radio signal is weak. Auto tuning will only detect radio stations with a good
signal. For more sensitive tuning, connect an outdoor antenna.
Problem Remedy
USB mass storage
device is not recognized
by the system. • Make sure you have completely inserted the USB connector to this unit.
• Check that the memory format is FAT16 or FAT32.
• USB devices with an internal USB hub are not supported.
Files don’t show up in
the Navigator/Photo
Browser. • The files must have the correct file extension: .mp3 for MP3 files; .wma for WMA
files; .m4a for MPEG-4 AAC files; .jpg for JPEG files (upper or lower-case is OK).
• Make sure the file permission hasn’t been restricted (through a password, etc.).
Can’t play WMA or
MPEG-4 AAC files. • The files were recorded using DRM (digital rights management). This is not a
malfunction.
Message Description
2CH ONLY • An operation is prohibited because it is only applicable to 2 channel sources,
while the current source is a multichannel source.
96K • An operation is prohibited because the source is 96 kHz digital.
SND. DEMO • The sound demo is on. See General in Troubleshooting on page 40.
NOISY • Background noise is too high to complete MCACC setup successfully.
XV-DV353_555.book 42 ページ ２００６年４月７日 金曜日 午後６時１８分