Panasonic DMR-E51 - Manual (Page 63)

63
Self-diagnosis
The self-diagnosis displays appear if a problem occurs with the unit.
The service numbers in the table appear when a problem occurs.
≥The service numbers are a “U” followed by two digits.
Service
number
Unit status Solutions
NO READ The disc is dirty or badly
scratched. ≥Follow the instructions in “Maintenance and Handling” to clean the disc if it is dirty.
(page 60)
≥The disc cannot be played if it is scratched and this display doesn’t disappear.
It can not be read for the
disk which doesn’t cope
with it. ≥It can not be read for the disk which doesn’t cope with it. Exchange a disk.
The DVD-RAM/PD lens
cleaner has finished
cleaning. ≥Take the cleaner out of the unit.
UNSUPPORT You have inserted a disc
the unit cannot play or
record on. ≥Insert a disc the unit can play or record on. (page 8)
U14 The unit is hot. ≥The unit switches to standby automatically for safety reasons and you cannot operate it.
Wait for about 30 minutes for the service number to disappear.
≥Select a position with good ventilation when installing the unit.
≥Do not block the cooling fan on the rear of the unit.
U99 The unit fails to operate
properly. ≥Press [Í/I] (1) to switch the unit to standby. Now press [Í/I] (1) again to turn the unit
on.
REMOTE
DVD The remote control code is
wrong. ≥Change to the correct code. (page 55)
RECOVER A power failure occurred
or the AC mains plug was
disconnected while the
power was ON. ≥The unit is carrying out its recovery process. Wait until the message disappears.
Service number
DVD(PAL).book 63 ページ ２００３年５月２２日 木曜日 午後１２時３分