Panasonic SC-DT310 EN - Manual (Page 7)

Simple setup
7
RQT6924
HF
LF
SPEAKERS
FRONT HF/LF
R
1 2 3 4 5 6
+
- L R L
SURROUND SUBWOOFER
(3≠) (6≠) (6≠) (6≠)
CENTER
1
FRONT
R ch
FRONT
LF Rch
FRONT
HF Rch
HF
LF
2
FRONT L ch
FRONT LF Lch
FRONT
HF Lch
3
SURROUND
R ch
SURROUND
R ch
HF
LF
FRONT
HF Rch
FRONT
LF Rch
150 mm
3
SURROUND
R ch
SURROUND
R ch
150 mm
150 mm 150 mm
SUB
WOOFER
6
SUB
WOOFER
1
FRONT
Rch
Speakers STEP
2
1 Attach the stickers to the speaker cables.
Attach the speaker-cable stickers to make connection easier.
FRONT L, R (4 m)
e.g.) FRONT R
2 Connecting the speakers
Match the labels on the speaker stickers with the labels on the terminals.
AV control receiver
SURROUND L,R (10 m)
e.g.) SURROUND R
CENTER, SUBWOOFER (4 m)
e.g.) SUBWOOFER
Speaker-cable stickers
Twist the same colored wires
together.
The subwoofer’s terminals are on the bottom.
Fit the cables into the slots provided.
From the side
From the rear
FRONT R
FRONT L
CENTER
SURROUND R
SUBWOOFER SURROUND L
Push the lever in the
direction indicated by the
arrow, insert the wire,
then release the lever.
Silver
Copper
Silver
HF: High Frequency
LF: Low Frequency
Copper: r
Silver: s
Connect center, surround L and
subwoofer in the same way.
To prevent damage to circuitry,
never short-circuit positive (r)
and negative (s) speaker wires.
Push the lever in the direction
indicated by the arrow, insert
the wire, release the lever and
press down on it lightly.
2 Speaker cables (4 wires, 4 m)
2 Speaker cables (2 wires, 4 m)
2 Speaker cables (2 wires, 10 m) Sheet of speaker-cable
stickers
Speaker cable
Copper
Silver
Copper
Copper: r
Silver: s
A noise filter comes attached with the speaker cables to
prevent undue influence to other equipment. Do not
remove the noise filter from the speaker cable.
Connect the noise filter side of the speaker cables to the
AV control receiver speaker terminals.