Panasonic BT-3DL2550E - Manual (Page 21)

21
How to Use the On Screen Menu
(continued)
1. Press [ADJUST] to display the picture/volume
adjusting menu.
2. Press [ , ] t o select item to adjust.
The selected item changes to white.
3. Press [ , ] to adjust.
PHASE 0 - 60 (30)
CHROMA 0, 10 - 60 (30)
BRIGHT 0 - 60 (30)
B.LIGHT [BACKLIGHT] 0 - 60 (50)
VOLUME 0 - 60 (0)
( ) : Factory defaults
•
Setting [B.LIGHT/CONT.] to CONT. [CONTRAST]
in the [SYSTEM CONFIG] menu changes the
B.LIGHT indication to CONT. enabling CONTRAST
adjustment.
CONT. [CONTRAST] 0 - 60 (50)
• Adjustments are not possible under the following
conditions.
- When “CONTROL” in the “CONTROL” menu is
set to “REMOTE,” the key mark appears and
adjustments cannot be changed.
- Setting the MONO function to ON (J page 30)
disables the [PHASE] and [CHROMA]
operations.
- During “RGB-COMP.” and “DVI-COMP.” input, the
[PHASE] and [CHROMA] operations are
disabled.
- During HV DELAY (J page 37) operation (and a
setting other than OFF is selected), [BRIGHT]
operation is disabled.
4. Press [ADJUST] to end adjustments. The display
is automatically closed after 10 seconds of
inaction.
•
The unit loads set values when the power is turned
on. Changed values are automatically saved after
10 seconds.
Picture/volume adjusting menu operations
BT-3DL2550PE(VQT2U10)_E.book 21 ページ ２０１０年７月８日 木曜日 午後２時１２分