Pioneer DV-566K-s - Manual (Page 72)

Additional information 10
72
En
Troubleshooting
Incorrect operation is often mistaken for trouble or malfunction. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie
in another component. Inspect the other components and electrical appliances being used. If
the trouble cannot be rectified after checking the items below, ask your nearest Pioneer
authorized service center or your dealer to carry out repair work.
Problem Remedy
The disc won’t play or is
automatically ejected
after loading. • Make sure the disc is free from dirt and dust and is not damaged
(
page 61 ).
• Make sure the disc is loaded with the label side face-up and aligned
properly in the disc tray guide.
• Incompatible region number: If the region number on a DVD-Video
disc does not match the number on the player, the disc cannot be
used (
page 65 ).
• Condensation inside the player: Allow time for condensation to
evaporate. Avoid using the player near an air-conditioning unit.
• Disc is loaded upside down: Reload the disc with the label side face
up.
• A Super VCD that does not conform with the IEC standards might
not play normally.
Picture playback stops
and the operation
buttons cannot be used. • Press , then start playback again ( ).
• Switch the power off once, unplug from the wall socket, then plug
back in and switch on again using the front panel
STANDBY/ON
button.
New settings made in the
Setup screen menus while
a disc is playing are
ineffective. • Some settings can be changed while a disc is playing, but are not
effective until the disc is stopped then restarted: Press
, then start
playback again ( ).
Settings are canceled. • When the power is cut due to power failure or by unplugging the
power cord, settings will be canceled: Press
STANDBY/ON on the
front panel to turn the player off. Wait for --OFF-- to disappear from
the display, then unplug the power cord.
No picture/No color. • Incorrect video connections: Check that connections are correct
and that plugs are inserted fully. Also check the video cable for
damage.
• TV/monitor or AV amplifier settings are incorrect: Check the
instruction manual of the connected equipment.
• The video output is set to progressive but your TV/monitor is not
compatible with progressive scan: See
page 53 for how to set to
interlace.
• When set to progressive video output, there is no video output from
the composite or S-video outputs.
DV566.book 72 ページ ２００３年６月１７日 火曜日 午後８時１８分