Polaroid SVGA 270 - Manual (Page 10)

1-9
O OP PE ER RA AT TIIO ON NS S ((cco on nttiin nu ueed d))
ENGLISH
Basic Operation
Basic manipulation to show in the table 1-2 can be done easily by the control panel of projector and
the attached remote controller. (The item of
⊕ can manipulate with the control panel.)
Table 1-2. Basic Operation
Use the remote control in front of the remote control photoreceptor at a distance of about
3 m or less and an angle of 30 degrees to the left or right of the center.Be careful of the
strong light and the obstacle because it sometimes obstructs remote controller
manipulation.
Item Description
INPUT
SELECT
Sequential switching of the input signal : Push INPUT button.
⊕
RGB → VIDEO → S-VIDEO (→ RGB)
The selection of input of RGB : Push RGB button.
VIDEO/S-VIDEO
→ RGB
The selection of input of VIDEO/S-VIDEO : Push VIDEO button.
RGB → VIDEO/S-VIDEO S-VIDEO ↔ VIDEO
*The signal name chosen at the time of a change in an input signal is
displayed for about three seconds.
POSITION
A setting/release of the centering control mode : Push POSITION button.
Icon [ ] is displayed by the centering control mode.
The accommodation of the image location : Push , , , button
by the centering control mode.
* It is effective by the VIDEO/S-VIDEO input only at the time of the
expansion mode.
* Icon [ ] disappears, and centering control mode is canceled
automatically when it passes for about 10 seconds under the condition
that manipulation isn't done.
RESET
⊕
The format of the menu item : Choose an appropriate item and push
RESET button.
The format of the centering control : Push RESET button by the
centering control mode.
MAGNIFY
The setting of the magnify mode : Push MAGNIFY button.
The movement of the magnify region : Do "centering control" by the
magnify mode.
The accommodation of the magnify multiplying factor : Push
MAGNIFY / by the magnifyn mode.
A release of the magnify mode : Push MAGNIFY button.
* Expansion is canceled due to the execution/setting of "AUTO" "ASPECT"
"VIDEO" or the change in the input signal.
OFF
FREEZE
A setting/release of the FREEZ mode : Push FREEZE button.
It is displayed, and an image rests by the rest mode icon [II].
* Rest is canceled due to the execution/setting of "centering control"
"sound volume" "noise reduction" "AUTO" "BLANK ON/OFF" or "MENU
ON/OFF", the change in the input signal.
* Be careful not to forget a release the static image when it rests.