No signal menu – Polaroid SVGA 270 User Manual
Page 16
1-15
O
OP
PE
ER
RA
AT
TIIO
ON
NS
S ((cco
on
nttiin
nu
ueed
d))
ENGLISH
No Signal Menu
The same adjustments and settings are available as with the Image and
Options menus when the MENUO button is pressed during display of the
‘NO INPUT IS DETECTED ON ***’ or ‘SYNC IS OUT OF RANGE
ON ***’ message while no signal is received. See Table 1.7 below.
Table 1.7 No Signal Menu
VOLUME
KEYSTONE
BLANK
MIRROR
START UP
MENU COLOR
TIMER
LANGUAGE
AUTO OFF
SYNC ON G
40
+1
Item
Description
VOLUME
Volume adjustment:
Reduce VOLUME
↔
Increase VOLUME
KEYSTONE
Adjustment:
Reduce size of bottom of image
↔
Reduce size of top of image
BLANK
Select blank screen color:
Select color with the
and
buttons.
* The image is cleared when the BLANK MODE is set with BLANK ON,
or when there is no signal, and the entire screen is displayed in the
selected color. Note that if TURN OFF is selected on the START UP
the blank screen is displayed in blue when there is no signal.
MIRROR
Operation start/stop:
Press
the or button.
Select Mirror status:
Select mirror status with
and
buttons.
START UP
Operation start/stop:
Press the
or
button.
Setup initial screen display:
Select TURN ON with the
button.
Clear initial screen display:
Select TURN OFF with the
button.
* Note that if TURN OFF is selected the blank screen is displayed in
blue when there is no signal.
MENU COLOR
Select menu background color:
Select with the
and
buttons.
TIMER
Operation start/stop:
Press
the or button.
Setup initial timer value:
Set 1~99 minutes with the
and
buttons.
LANGUAGE
Operation start/stop:
Press
the or button.
Select menu display language:
Select with the
and
buttons.
AUTO OFF
Operation start/stop:
Press
the or button.
Set AUTO OFF:
Set 0~99 minutes with the
and
buttons.
The system automatically enters the standby mode when a signal is
not received for the set time.
Clear AUTO OFF:
Select STOP (0 min.) with the
button.
Wind Stop is selected the system does not enter the standby mode
even if no signal is received.
SYNC ON G
Operation start/stop:
Press
the or button.
SYNC ON G valid:
Select TURN ON with the
button.
SYNC ON G invalid:
Select TURN OFF with the
button.
* When SYNC ON G is effective, it may not be displayed normally by an input
signal. Remove a signal connector, and make it condition without a signal, and
input a signal again in this case SYNC ON G after it is overridden.