Pentair INTELLIFLO VS-3050 - Manual (Page 11)

11
Starting the pump
To start the pump
1. Ensure that the pump is powered on and the green power LED is on.
2. Press the Start button (LED on) to start the pump.
Note: When the pump is using a modified speed and is powered down, the next time the pump is
powered up, the pump will use that same speed.
Stopping the pump
To stop the pump
• Press the Stop button to stop the pump.
Note: The pump can automatically restart if the communication cable is connected.
Resetting the pump to factory defaults
The IntelliFlo ® VS pump can be reset to the factory default settings. All previously adjusted pump speeds
that were saved will be erased.
To reset the pump to the factory default settings:
1. Ensure that the pump is powered on and the green power LED is on.
2. Press the Stop button to stop the pump.
3. Press and hold all of the four Speed buttons simultaneously for three seconds. Power off the
drive and reenergize. The default settings will be in effect.
Control Panel Speed Buttons
English