Panasonic KX-FLB851 - Manual (Page 17)

1. Introduction and Installation
15 For assistance, please visit http://www.panasonic.com/consumersupport
1.7.2 Installing the output tray
Insert the output tray (
1) into the slots (2), then
push the tray down until it latches into place.
L Repeat this step to install other output trays.
L Make sure that the number on the label and
the tray position match.
Note:
L Do not place the unit in an area where the
output tray may be easily bumped into.
L The upper output tray can hold up to
approximately 100 sheets of printed paper.
The other output trays can hold up to
approximately 50 sheets of printed paper.
Remove the printed paper before the output
tray becomes full.
1.8 Recording paper
1.8.1 Using the paper input tray
A4 or letter size recording paper can be used.
The paper input tray unit can hold:
–
Up to 250 sheets of 60 g/m
2
to 75 g/m
2
(16 lb.
to 20 lb.) paper.
– Up to 230 sheets of 80 g/m
2
(21 lb.) paper.
– Up to 200 sheets of 90 g/m
2
(24 lb.) paper.
L Please refer to page 93 for information on
recording paper.
L The unit is set for letter size paper by
default. If you want to use A4 size paper,
change the setting:
–
by using {PAPER TRAY} in the copy
mode (page 44).
– in feature #380 (page 62).
1 Pull open the paper input tray ( 1).
2 Pinch the right side of the recording paper
guide (
1), then slide it to match the paper
size mark.
Pinch the front side of the recording paper
guide (
2), then slide it open to its full width.
2
1
1
1
2
FLB851-PFQX2175YA-en.book Page 15 Thursday, September 8, 2005 2:24 PM