Panasonic ET-MD77NT - Manual (Page 3)

3
ET-MD77SD1
SD-SDI Board for DLP™ Projector
S P E C F I L E
As of December 2006
204
(8-1/32˝)
214
32
(8-7/16˝)
(1-1/4˝)
Specifications
Power supply: Provided from the DLP™ projector
Power consumption: Projector power consumption increases approximately 5 W
Terminals: Serial input: BNC x 1, 4:2:2 digital serial component signal, SMPTE 259M compliant,
480i, 576i
Serial output: BNC x 1, active through
LAN: RJ-45 x 1, 10Base-T/100Base-TX for network connection
Dimensions (W x H x D): 204 x 32 x 214 mm (8-1/32˝ x 1-1/4˝ x 8-7/16˝)
Weight: 290 g (10.2 lbs.)
Operating temperature: 0°C – 40°C
Operating humidity: 10% – 80% (no condensation)
Weights and dimensions shown are approximate.
Specifications subject to change without notice.
DLP and DLP logo are trademarks of Texas Instruments.
This board is designed for use with the DLP™ projectors. It enables the input of a 4:2:2 digital serial component
signal (SMPTE259M-compliant). Remote control of the projector is also possible from an external computer
connected via LAN.
NOTE: Please use the module only on the specified Panasonic DLP™ projector.
Dimensions
unit: mm
(Dimensions given in inches are approximate.)
Note: This illustration is not drawn to scale.