Panasonic ET-MD77NT - Manual (Page 5)

204
(8-1/32˝)
214
(8-7/16˝)
32
(1-1/4˝)
S
P E C
F
I L E
ET-MD100SD4
HD-SDI Input Board for the PT-DW10000
As of February 2008 < 1 >
Specifications
Power supply: Provided from the DLP™ projector
Power consumption: Projector power consumption increases approximately 10 W
Terminals: Link A/Link B input: BNC x 1 for each
SD-SDI signal (YC B C R 4:2:2 10 bit)
SMPTE 259M compliant: 480i, 576i
Single link HD-SDI signal (YC B C R 4:2:2 10 bit)
SMPTE 292M compiant: 1720/50p, 720/60p, 1080/50i, 1080/60i, 1080/25p,
1080/24p, 1080/24sF, 1080/30p
Dual link HD-SDI signal (RGB 4:4:4 12 bit/10 bit)
SMPTE 372M compiant: 1920 x 1080/50i, 1920 x 1080/60i, 1920 x 1080/25p,
1920 x 1080/24p, 1920 x 1080/24sF, 1920 x 1080/30p
Dual link HD-SDI signal (X´Y´Z´ 4:4:4 12 bit)
2048 x 1080/24p, 2048 x 1080/24sF
Dimensions (W x H x D): 204 x 32 x 214 mm (8-1/32˝ x 1-1/4˝ x 8-7/16˝)
Weight: 250 g (8.8 oz)
Operating temperature: 0°C – 45°C (32°F – 113°F)
Operating humidity: 10% – 80% (no condensation)
Weights and dimensions shown are approximate. Specifications subject to change without notice.
DLP and the DLP logo are trademarks of Texas Instruments. All other trademarks are the property of their respective trademark owners.
NOTE: Please use the module only on the Panasonic DLP™ projector PT-DW10000.
NOTE: Use connection cables of 5CFB or higher (ex. 5CFB, 7CFB, 5CFTX, etc.).
unit : mm (inch)
NOTE: This illustration is not drawn to scale.
Dimensions
This board is designed for use with the DLP™ projector PT-DW10000. It enables the input of a HD-SDI (SMPTE
292M) and dual link HD-SDI (SMPTE 372M). Remote control of the projector is also possible from an external com-
puter connected via LAN.