Pelco ESPRIT ES3012 - Manual (Page 19)

Pelco Manual C306M-K (4/05) 19
AZ/EL LINE
Az/El Line controls the vertical display position of the Azimuth/Elevation label. The label
may be displayed on lines 3 through 10. Line 3 is the third line from the top of the screen
and line 10 is located at the bottom of the screen. Line 10 is the default setting.
To program the vertical label position for Az/El:
1. Program preset 95 (28). The main menu appears.
2. Position the cursor (>) beside Other.
3. Press the Iris Open button to enter the Other menu.
4. Position the cursor (>) beside Az/El/Direction.
5. Press the Iris Open button to enter the Az/El/Direction menu.
6. Position the cursor (>) beside Az/El Line.
7. Press the Iris Open button. The cursor moves to the right.
8. Move the joystick up or down to view the available selections.
9. SELECT – Press the Iris Open button to make a selection.
CANCEL – Press the Iris Close button to cancel a selection.
Other Menu
Park Time 0
Pan/Scan Spd 7
Power Up Default
Pat length 6 min
Spd Profile 50 MPH wind
<Zone Blank>
<Az /El/Direction>
Exit
Az/El/Direction
Set Azimuth Zero
Az/El
Az/El Line
Direction
Direction Line
Disp Duration
Exit
MAIN MENU
<Limit Stop>
<Other>
EXIT
NOTE: Az/El display is not
available while you are
programming or running a
pattern.