Profoto Pro-B2 - Manual (Page 8)

Pro-7 ring
The ring flash fits all Pro-7 generators, and is an entirely
mobile source of light. The interior diameter of 100 mm
provides plenty of space for professional camera lenses.
Since the camera holder can be tilted forward and back-
wards, as well as upwards and downwards, most cameras
can be attached. This makes an excellent source of light in
cramped areas, such as the interior of an automobile.
Many fashion photographers also use the ring flash to find
new angles and capture details. The ring flash provides a
very distinct, directed light, but can be complemented by
a soft or a widesoft Reflector, which increases the light
source, thereby producing a softer light with fewer sharp
shadows. For close-ups, there is a reflector that focuses
the light 50 cm in front of the camera lens. The maximum
charge is 9600Ws per minute. This means 4 flashes a
minute at 2400 Ws, 8 flashes at 1200 Ws, 16 flashes at
600 Ws, etc. Changing flash tube is only to be done at a
professional servicestation.
Mounting the reflector
.
Remove the two ridged screws fixating the
camera holder.
.
Remove the four ridged nuts holding the outer
and inner reflectors together.
.
Run the lamp cable through the outer reflector
and let the reflector slide into position.
.
Reassemble the outer and inner reflectors using the
ridged nuts.
.
Reassemble the camera holder using the two
ridged screws.
Pro -B2 Profoto – Heads
Profoto 14 The Light Shaping Company
Profoto
Pro-B2 Generators
Profoto – Generators Pro -B2